Beretta A400, 1301 Stock Bolt

Part is nice. Too long for a newer A400 Xcel Sporting that has the kickoff in the middle of the butt stock. I fits great if you have the kickoff on the end of the stock. Replaced the stock with a replacement stock that is one piece and ordered this. Beretta and Midwest said it should fit. We have an older A400 with the kickoff on the end so I will use it there if I ever remove the kickoff and replace the stock.

Hi guys, Great factory stock bolt and service from MGW! I bought this to replace the factory stock bolt on a Beretta Upland KO 12 gauge shotgun. It was necessary to be the proper length for a non KO stock which took a different length to work around the internal, mid stock kickoff unit. The factory one had thread locker, but I was able to manually twist it out against resistance by placing the receiver, with thick padding, in a bench vise and using channel lock vise grips with 10 inch handles; came right out. I did not thread lock. IF you don't have a vise, you might clamp the gun to a table top. The trickiest part of this stock change was placing the cast off shim, lock washer over the bolt and starting the nylock nut on the shaft. It required a magnetic pick up device and a push button grabber to accomplish that, along with a 13mm deep socket, 3/8 drive.

Putting a custom stock on my A400 and you had the exact stock bolt I needed.